Draytek Vigor2920n User Manual page 197

Activate
Setup Query Server
Setup Test Server
Find more
Test a site to verify
whether it is categorized
Set to Factory Default
Cache
Click it to access into MyVigor for activating WCF service.
It is recommended for you to use the default setting,
auto-selected. You need to specify a server for categorize
searching when you type URL in browser based on the web
content filter profile. Such server is powered by
Commtouch.
It is recommended for you to use the default setting,
auto-selected. Such server is powered by Commtouch.
Click it to open http://myvigor.draytek.com for searching
another qualified and suitable server.
Click this link to do the verification.
Click this link to retrieve the factory settings.
None – the router will check the URL that the user wants to
access via WCF precisely, however, the processing rate is
normal. Such item can provide the most accurate URL
matching.
L1 – the router will check the URL that the user wants to
access via WCF. If the URL has been accessed previously, it
will be stored for a short time (about 1 second) in the router
to be accessed quickly if required. Such item can provide
accurate URL matching with faster rate.
L2 – the router will check the URL that the user wants to
access via WCF. If the data has been accessed previously,
the IP addresses of source and destination IDs will be
memorized for a short time (about 1 second) in the router.
When the user tries to access the same destination ID, the
router will check it by comparing the record stored. If it
185
Vigor2920 Series User's Guide