Procedure 3.1 - Software Access Codes - Precor C556 Service Manual

Procedure 3.1 - Software Access Codes

The C556 uses the standard access codes to provide access to the various software features. In
using the standardized access codes the keys are hypothetically numbered left to right with key
#1 on the far left and key #7 on the far right. The standard access codes use all sequential key
presses. The allowable delay between key presses is short. If too much time is taken between
key presses the access procedure will be aborted. If the access is aborted, it will be necessary to
start over from the beginning. See Diagram 3.1. The C556 display does not utilize key positions
#2 and #3, however, they must be counted to correctly locate keys #4 through #6. On the C556
display key #1 is the RESET key and key #4 is the QUICK START key.
Standard Access Codes
Diagnostics
Odometer
Club Settings
Diagram 3.1 - C556 Display Panel
C556 Elliptical Fitness Crosstrainerl
Keys RESET,5,1,7,6,5,7,6,1
Keys RESET,6,5
Keys RESET,5,6,5,1,5,6,5
Page 7