Table of Contents
Advertisement
3. If you are unfamiliar with using the operator panel to work with menus,
please read "Using the Operator Panel Keys" on page 23 and "Navigating
Menus" on page 24 before continuing.
4. See "Defining Custom Form Sizes for IPDS" on page 66 for an example of
defining a custom form.
5. Custom forms can only be fed from the auxiliary tray.
|
Custom Forms
Menu Item
MM*
FORM1UNITS
IN
nnn
FORM1 LEN
nn.n
nnn
FORM1 WIDTH
nn.n
FORM2UNITS
FORM2 WIDTH
FORM2 LEN
FORM3UNITS
FORM3 WIDTH
FORM3 LEN
FORM4UNITS
FORM4 WIDTH
FORM4 LEN
FORM5UNITS
FORM5 WIDTH
FORM5 LEN
Configuration (Config) Menu
Use the Configuration Menu to configure the printer. The following table
describes the settings you can change from the Configuration Menu. An
asterisk (*) next to a value in the table indicates the factory default.
Notes:
1. To select a new value, press the Enter key when the value is displayed in
the message display area. An asterisk (*) appears next to the value in the
message display area, indicating that it is now active.
Value
Specifies the unit of measurement for the custom form.
Specifies the width of the custom form. If FORMUNITS is
set to millimeters, acceptable values are 148 to 508
millimeters. If FORMUNITS is set to inches, acceptable
values are 5.9 to 20.0 inches.
Specifies the width of the custom form. If FORMUNITS is
set to millimeters, acceptable values are 88 to 330
millimeters. If FORMUNITS is set to inches, acceptable
values are 3.5 to 13.0 inches.
Specifies up to four more custom forms. See FORM1UNITS,
FORM1 LEN, and FORM1 WIDTH for a description of each
field.
Description
Chapter 6. Operator Panel Menus
95
Advertisement
Table of Contents
