Table of Contents
Advertisement
IPDS Menu Item
ON*
VPA CHK
OFF
X-OFFSET
nnn
Y-OFFSET
nnn
Value
Turns valid printable area checking on or off.
v ON—the printer checks for pels that fall outside the
intersection of the logical and physical pages. If pels fall
outside the area, the printer reports an error to the host if
the IPDS Exception Handling Control command setting
requires error reporting.
v OFF—The printer does not report pels outside the valid
printable area.
Sets the print offset in the X (horizontal) direction. nnn can
be from -999 to 999. The default setting is 0 pels. Positive
values move the starting point for printing to the right of
the physical point of origin. Negative values move the
starting point for printing to the left. The physical point of
origin is towards the top left corner of a portrait page. If
you rotate the page, the physical point of origin rotates as
well.
Note: The X-OFFSET and Y-OFFSET options are intended to
allow line printer print jobs to fit on a page where
edge-to-edge printing is not possible. Using X-OFFSET and
Y-OFFSET is NOT recommended when generating new
applications, especially duplex applications.
Sets the print offset in the Y (vertical) direction. nnn can be
from -999 to 999. The default setting is 0 pels. Positive
values move the starting point for printing down from the
physical point of origin. Negative values move the starting
point for printing up. The physical point of origin is
towards the top left corner of a portrait page. If you rotate
the page, the physical point of origin rotates as well.
Note: The X-OFFSET and Y-OFFSET options are intended to
allow line printer print jobs to fit on a page where
edge-to-edge printing is not possible. Using X-OFFSET and
Y-OFFSET is NOT recommended when generating new
applications, especially duplex applications.
Description
Chapter 6. Operator Panel Menus
107
Advertisement
Table of Contents
