Table of Contents
Advertisement
sockets in the socket group of three. The IPDS SIMM and the flash
memory SIMMs must be installed in one of the sockets in the socket group
of four.
SIMMs should be loaded from the left to the right but the position of the
SIMM within the group of sockets does not matter.
4. Hold the SIMM with the notch facing the socket and the notch at the top.
|
Insert the SIMM at a 45 degree angle and move it into position in the
|
socket. Using your thumbs, press with even pressure on both ends of the
|
SIMM until the SIMM is firmly seated in the socket.
|
Make sure the clips on either end of the socket snap into place to hold the
|
SIMM. If necessary, use your thumbs to move the clips upright into the
|
grooves to lock the SIMM in place.
|
5. Verify that the SIMM is correctly installed in the socket by looking at its
position from the sides of the controller card.
6. Reinstall the side cover. Follow the procedure "Reinstalling the Side
Cover" on page 152.
150
InfoPrint 20: User's Guide -- CD Version
Advertisement
Table of Contents
