IBM InfoPrint 20 User Manual page 218

+ FORMAT DISK/- IGNORE DISK
FLUSHING...
FORMATTING
F/W xxxxxxx
I/O INITIALIZING
- IGNORE DISK/+ FORMAT DISK
IPDS COAX
IPDS ETHERNET
208
InfoPrint 20: User's Guide -- CD Version
Meaning: You are powering up with an unformatted hard drive, or
you selected the FORMAT DISK action on the Test Menu.
Action: Press the Value key to format the hard drive. Press the Shift
and Value keys simultaneously to continue as if there were no hard
drive installed.
Meaning: The printer is canceling a PCL5e or PostScript job.
Action: None required.
Meaning: The printer is formatting the hard drive.
Action: None required.
Meaning: Firmware error (xxxxxxx can be any alphanumeric value).
Action: Power the printer off, wait ten seconds, and power the printer
back on. If problems persist, call for technical support.
Note: When firmware errors occur, the printer might also print an
error page. If the printer does print an error page, save it so
you can tell technical support.
Meaning: The network interface card is initializing.
Action: Normally none. If the message remains on the display and
nothing prints, and you have an Ethernet or token-ring card, make
sure your LAN cable is connected and the network interface card is
seated.
Meaning: You are powering up with an unformatted hard drive, or
you selected the FORMAT DISK action on the Test Menu.
Action: Press the Value key to format the hard drive. Press the Shift
and Value keys simultaneously to continue as if there were no hard
drive installed.
Meaning: The printer is receiving IPDS data through the coax
interface.
Action: None required.
Meaning: The printer is receiving IPDS data through the Ethernet
interface.