Sp5-Xxx (Mode) - Ricoh K-C3 Service Manual

B245/B276/B277/B268/B269 Service Manual
4932 1 Sharpness- Low ID (Copy)
White Line Erase
4941*
Selects the white line erase level.
0: None, 1: Weak, 2: Strong
4941 1 This setting is effective only Photo 1, Photo 3, Special 3 or Special 4 mode.
0: White line erase is not used, and white level
This setting is applied regardless of what mode has been selected in SP 4921.
Black Line Erase
4942*
Selects the black line erase level. This setting is effective only when originals
are scanned by the A(R)DF.
4942 1
[0 = No / 1 = Very weak / 2 = Weak / 3 = Strong]
This setting is applied regardless of what mode has been selected in SP 4921.

SP5-XXX (Mode)

All Indicators On
5001
All LEDs turn on. The LCD turns on or off every 3 seconds. Press the reset
5001 1
key to end this program.
[Accounting count]
5045*
5045 1 Selects the counting method to either developments or prints.
A3/DLT Double Count
5104*
Selects whether the machine counts twice for each sheet of A3/11"x 17". If this
5104 1 is set to "Yes" is selected, the total (mechanical) counter and the current user
counter will both increment by two for each A3/11" x 17" sheet.
Optional Counter Type
5113*
5113 1 Selects the corresponding key for installed devices such as coin lock.
Clr-OP Count Remv
5120*
Determines under which conditions the copy job settings are reset when the
key counter is removed. With 0, the settings are cleared if the counter is
removed at the end of a job or midway through a job. With 1, they are only
5120 1
cleared if the counter is removed at the end of a job. With 2, they are not
cleared at all, under either condition. With duplex copies, the job settings are
always preserved, regardless of the setting of this SP mode.
Count Up Timing
5121*
Selects whether the key counter increments at time of paper feed-in or at time
5121 1
of paper exit.
[0 ~ 2 / 1 / 1/step]
[0 ~ 3 / 2 / 1/step]
[0 to 1 / 1 / -]
0: Developments, 1: Pages
[0 = Enabled / 1 = Disabled /
2 = Disabled if the size is undetected]
0: None
11: MF key card (Increment)
12: MF key card (Decrement)
[0=Yes / 1=Standby only / 2=No]
[0 = Feed In / 1 = Exit]
18-Jan-06
correction is used instead·
146