Table of Contents
Advertisement
GLASS & SCREEN ASSEMBLY PLACEMENT
1. Place the bottom of the glass assembly into the firebox and
angle the top in.
Ensure the bottom glass clips engage to the glass assembly.
2.
Secure the glass assembly in place with one hand.
3. Insert the Latch Tool into the firebox at the top and hook it
onto the right glass clip.
4.
Using steady force, pull the latch out and up until it engages
to the glass assembly.
5.
Repeat step 4 through 5 for the left glass clip.
Top glass clips are tightly sprung. If the Latch tool slips off of
the clip while pulling, injury may occur. Ensure that the latch
tool is completely hooked around the glass clips before trying
to engage the glass clips to the glass assembly.
Page 14
CAUTION
Figure 15
Figure 16
CAUTION
6.
Place the screen on the four pegs (two each side) on the
firebox. Secure with two screws (one each side) as shown in
Figure 17.
Figure 17
34961-2-1015
Advertisement
Table of Contents
