Table of Contents
Advertisement
14. Slide the burner to the right and lift out. See Figure 46.
NOTICE: Sliding the burner to the right ensures that the
orifice disengages from the venturi.
15. Remove the two screws securing the "air box" to the rear of
the firebox. Remove the "air box" and set aside. See Figure
47.
16. Remove the 18 screws securing the blower access panel to
the firebox and set aside. Remove the blower access panel
and set aside. See Figure 48.
34961-2-1015
BLOWER REMOVAL/REPLACEMENT
Figure 46
Figure 47
Figure 48
17. Pull blower far enough through the blower access hole to
disconnect the wires at the connectors. See Figure 49. Once
the wires are disconnected, remove blower completely and
discard.
19. Install the replacement blower, and re-install the insert by
reversing the above steps.
Figure 49
Page 27
Advertisement
Table of Contents
