Glass Assembly Placement - Empire Comfort Systems TRADITIONAL DXT30IN LP Installation Instructions And Owner's Manual

1. Place the bottom of the glass assembly into the firebox and
angle the top in.
Ensure the bottom glass clips engage to the glass assembly.
2. Secure the glass assembly in place with one hand.
3. Insert the Latch Tool into the firebox at the top and hook it
onto the right glass clip.
4. Using steady force, pull the latch out and up until it engages
to the glass assembly.
5. Repeat steps 2 through 4 for the left glass clip.
Top glass clips are tightly sprung. If the Latch tool slips off of
the clip while pulling, injury may occur. Ensure that the latch
tool is completely hooked around the glass clips before trying
to engage the glass clips to the glass assembly.
Page 16

GLASS ASSEMBLY pLACEMENT

CAUTION
Figure 15
CAUTION
Figure 16
1. Slide the air deflector into place as shown in Figure 17.
Secure the air deflector to the outer firebox with the two
#8 x 1/2" Phillips truss head screws (provided). See Figure
17.
Figure 17
31210-1-0713