Table of Contents
Advertisement
OPTIONAL DECORATIVE GLASS PLACEMENT
WARNING:
Failure to position the parts in accordance with
the diagrams and instructions below or failure
to use only parts specifically approved for use
with this heater may result in property damage
or personal injury.
NOTE: The DVL Fireplace may be operated with or without
the Decorative glass accessory options. Follow the
directions below should you choose to enhance your
Loft Fireplace with any one of the available decora-
tive glass options.
DECORATIVE GLASS ACCESSORY PLACEMENT
The Decorative Glass options are available in various colors and
package sizes. Choose the proper size kit for use with your par-
ticular Loft Fireplace. See Page 38.
CAUTION: Use of gloves and eye protection is required while
applying the decorative glass.
INSTALLATION
1.
Application of the Decorative Glass should only be performed
after the DVL Fireplace has been fully installed, secured
and tested for leaks. If operating the burner with a Remote
Control, make sure all batteries are installed and that the
burner operates with the remote correctly.
GLASS MUST NOT BE PLACED ON TOP OF OR
NEXT TO BURNER. GLASS TO BE PLACED ONLY
TO THE OUTSIDE OF THE FLANGED OPENING.
29210-0-0911
DECORATIVE GLASS
Figure 45
2.
To install the Decorative Glass, cut off a corner of the plastic
bag and proceed to apply the glass to the rear shelf on the
Loft burner cover (area behind the burner). See Figure 45. Ap-
ply only enough glass to cover the black metal surfaces. Do
not allow the glass to fall around the burner tube. See Figure
46. Apply the remaining decorative glass to the front sloped
surface of the Top Cover. Start by placing the glass along the
front edge of the top cover, then gradually place the glass up
the sloped top cover until completely covered. Do not allow
the glass to fall around the burner tube. See Figure 47.
CAUTION: Glass must not be placed on the burner.
Figure 46
Figure 47
Page 31
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
