Optional Decorative Glass Placement - Empire Comfort Systems DVL25IN33N-1 Owner's Manual

OpTIONAL DECORATIvE GLASS pLACEMENT

WARNING: Failure to position the parts in accordance with
the diagrams and instructions below or failure
to use only parts specifically approved for use
with this heater may result in property damage
or personal injury.
NOTE: The DvL Fireplace Insert may be operated with or
without the Decorative glass accessory options. Fol-
low the directions below should you choose to en-
hance your Loft Fireplace Insert with any one of the
available decorative glass options.
DECORATIvE GLASS ACCESSORY pLACEMENT
The Decorative Glass options are available in various colors and
package sizes. Choose the proper size kit for use with your par-
ticular Loft Fireplace Insert. See Page 31.
CAUTION: Use of gloves and eye protection is required while
applying the decorative glass.
INSTALLATION
1. Application of the Decorative Glass should only be
performed after the DVL Fireplace Insert has been fully
installed, secured and tested for leaks. If operating the burner
with a Remote Control, make sure all batteries are installed
and that the burner operates with the remote correctly.
DECORATIVE GLASS
GLASS MUST NOT BE PLACED ON TOP OF OR
NEXT TO BURNER. GLASS TO BE PLACED ONLY
TO THE OUTSIDE OF THE FLANGED OPENING.
Page 18
Figure 19
2. To install the Decorative Glass, cut off a corner of the plastic
bag and proceed to apply the glass to the rear shelf on the
Loft burner (area behind the burner). Apply only enough glass
to the Top Cover to cover the black metal surfaces. Do not
allow the glass to fall around the burner tube. See Figure 19.
Apply the remaining decorative glass to the front sloped
surface of the Top Cover. Start by placing the glass along the
front edge of the top cover, then gradually place the glass
up the sloped top until completely covered. Do not allow the
glass to fall around the burner tube. See Figure 20.
CAUTION: Glass must not be placed on the burner.
Figure 20
Figure 21
30368-8-1113