Table of Contents
Advertisement
The appliance, when installed, must be electrically con-
nected and grounded in accordance with local codes or,
in the absence of local codes, with the current CSA C22.1
Canadian Electrical Code.
U.S. Installations, follow local codes and the National
Electrical Code, ANSI/NFPA No. 70.
Should this blower require servicing, the power supply
must be disconnected. For rewiring of any replacement
components, refer to the wiring diagram on page 18, and
the parts list on Pages 30 and 31.
The fireplace insert is equipped with a factory installed blower.
Blower Removal/Replacement Instructions - From the Rear
Servicing or removal of the blower system must be performed by
a qualified service person.
If the blower assembly must be replaced, the following steps are
recommended for removal:
1.
Turn off gas and disconnect the electrical supply.
2.
Remove the Decorative Front and Surround from the unit.
3.
Carefully pull unit away from the wall to gain access to the
venting. Remove venting from the appliance.
4. Pull Insert out of fireplace to gain access to the rear of the
appliance.
5. Remove the two screws securing the bottom flange to the
firebox. See Figure 43.
6. Hand bend the flange so that lays flat. See Figure 43.
7.
Remove blower from appliance and disconnect the wires at
the connectors and discard blower (if applicable).
8.
Install the replacement blower, and re-install the insert by
reversing above steps.
Page 26
BLOWER REMOVAL/REPLACEMENT
Figure 43
Blower Removal/Replacement Instructions - From the Front
Servicing or removal of the blower system must be performed by
a qualified service person.
If the blower assembly must be replaced, the following steps are
recommended for removal:
1.
Turn off gas and disconnect the electrical supply.
2.
Remove the Decorative Front and Surround from the unit.
Refer to the instructions that came with your Front for more
information.
3.
If applicable, remove Fireplace Screen. See page 13 for
more information.
4.
Remove Glass Front Assembly. See page 13 for more infor-
mation.
5.
Remove Decorative Glass Media. See page 16.
6.
Remove the liners. Refer to the instructions that came with
your liners for more information.
11. Remove the two screws securing the pilot to the burner. See
Figure 44.
12. Pull the pilot toward the back of the unit just enough to get
it safely out of the way. See Figure 44. DO NOT disconnect
the pilot.
13. Remove the left and right screws securing the burner to the
firebox. See Figure 45.
Figure 44
Figure 45
34961-2-1015
Advertisement
Table of Contents
