General Description
1.4.7
Resolution Improvement Technology
The
printers have
to improve print quality at 600
the image data is reassembled to improve print data.
main improvement of this technique is m
effective when the dot map data fits the development characteristics of the printer mechanism well.
It is therefore necessary to set appropriate values in
is not as effective for printing a mesh pattern or gray scale. In such cases,
Note:
must be set to OFF. ('The
depends on the toner condition, it should be adjusted when the imaging cartridge is
replaced or after the imaging cartridge is used for a long time.
following settings are available in
When the toner density of area A is almost the same as that of area B (as shown m the figure
below), the
setting is at its optimum setting. In other words, the optimum setting is
achieved when it is difficult to distinguish the shape of area A from that of B.
1-32
(Bi Resolution Improvement Technology), which is designed
300
By this method, the dot map data extracted from
inch
I
printing)
(When 600
Figure 1-14. Effect of
default setting is MEDIUM.) Since the
Level for
Figure 1-15.
in diagonal lines. It is most
1 inch
DARK, MEDIUM, LIGHT, OFF.
Adjustment
"
600
effect
Rev.
.