Low Voltage Supply Unit Unit) Removal - Epson EPL-9000 Service Manual

Service Manual
3.2.2.5 Low Voltage Supply Unit
Remove the rear cover. (Refer to Section 3.2.1.1.)
1.
2. Remove the top cover. (Refer to Section 3.2.1.2.)
Remove the left cover. (Refer to Section 3.2.1.3.)
3.
Remove the right cover. (Refer to Section 3.2.1.4.)
4.
Remove the ELEC cover. (Refer to Section 3.2.2.1.)
5.
Disconnect the connector
6.
board.
7.
Remove 3 screws
8. Remove the fusing unit. (Refer to Section 3.2.5.1.)
9.
Remove 1 CB screw
10.
Remove 2 CBB screws
fusing unit.
11. Remove 2 CB screws
remove it.
12. Remove the saddle edge H from the
Rev.
Unit) Removal
securing the
x 6)
Figure 3-10. Removing the
x 6) securing the earth wire of the HVPS board to the
x 10) securing the ROS unit, and remove connector P101 of the
x 6) and CBS(0) screw
unit.
Figure 3-11. Removing the
Disassembly and Assembly
6,
box, and remove it and the
Box
x 6) securing the
Unit
on the
board.
unit.
unit, and
3-9