Service Manual
Fusing Unit Removal and Disassembly
3.2.5
This section describes how to remove and disassemble the fusing unit.
3.2.5.1 Fusing Unit Removal
1.
Remove the top cover. (Refer to Section 3.2.1.2.)
2. Disconnect
3 Remove CB screw
4. Loosen 2 screws securing the fusing unit, and remove it.
3.2.5.2 Pressure Roller Removal
1.
Remove the top cover. (Refer to Section 3.2.1.2.)
2. Remove the fusing unit. (Refer to Section
3 Remove 2
screws
4. Remove 2
screws
5. Remove 2
screws
6. Remove 1 CB screw
7. Remove the pressure roller.
Figure 3-38. Removing the Pressure
Rev.
from the eject sensor.
x 6) securing the fusing unit.
Figure 3-37. Removing the Fusing Unit
x 8) securing the fusing unit top cover,
x 8) securing the fusing unit cover R, and remove it.
x 8) securing the fusing unit cover L, and remove it.
x 6) on the fusing unit frame.
Disassembly and Assembly
remove it.
and
Roller
3-23