D-Link DGS-3324SRi User Manual page 82

D-Link DGS-3324SRi Intelligent Stackable Gigabit Ethernet Switch
Type
Vlan
Source Mac
Destination Mac
802.1p
Ethernet type
Port
To add an entry to the Access Profile Table, click the Add button. This will open the Access Profile
Configuration page, as shown below. There are two Access Profile Configuration pages − one for Ethernet
(or MAC address-based) profile configuration, and one for IP address-based profile configuration. You can
switch between the two Access Profile Configuration pages by using the Type drop-down menu, and clicking
on the Apply button. The page shown below is the IP Access Profile Configuration page.
be set from 1 – 8.
Select profile based on Ethernet (MAC Address) or IP address. This will
change the menu according to the requirements for the type of profile.
Select Ethernet to instruct the Switch to examine the layer 2 part of each
packet header. Select IP to instruct the Switch to examine the IP address
in each frame's header.
Selecting this option instructs the Switch to examine the VLAN part of each
packet header and use this as the full or partial criterion for forwarding.
Source MAC Mask - Enter a MAC address mask for the source MAC
address.
Destination MAC Mask - Enter a MAC address mask for the destination
MAC address.
Selecting this option instructs the Switch to examine the 802.1p priority
value of each packet header and use this as the, or part of the criterion for
forwarding.
Selecting this option instructs the Switch to examine the Ethernet type
value in each frame's header.
The user may set the Access Profile Table on a per-port basis by
entering an entry in this field. The user may select all, denoting all ports
within the switch stack, or enter a port or ports. The port list is specified by
listing the lowest switch number and the beginning port number on that
switch, separated by a colon. Then the highest switch number, and the
highest port number of the range (also separated by a colon) are specified.
The beginning and end of the port list range are separated by a dash. For
example, 1:3 specifies switch number 1, port 3. 2:4 specifies switch
number 2, port 4. 1:3-2:4 specifies all of the ports between switch 1, port 3
and switch 2, port 4 − in numerical order.
67