Configuring Sntp Settings; Time Settings - D-Link DGS-3324SRi User Manual

D-Link DGS-3324SRi Intelligent Stackable Gigabit Ethernet Switch

Configuring SNTP Settings

The Simple Network Time Protocol (SNTP) {an adaptation of the Network Time Protocol (NPT)} is
configured on the Switch using the following pages.

Time Settings

To configure the time settings for the Switch, open the Configuration folder, then the SNTP folder and click on
the Time Setting link, revealing the following screen for the user to configure.
The following parameters can set or are displayed:
Parameter
System Boot Time
Time Source
SNTP State
SNTP Primary
Server
SNTP Secondary
Server
SNTP Poll Interval in
Figure 4- 35. Time Settings Page
Description
Displays the beginning time of the current session of the Switch.
Displays the time source for the system.
Use this pull-down menu to enable or disable SNTP.
This is the primary server the SNTP information will be taken from.
This is the secondary server the SNTP information will be taken from.
This is the interval, in seconds, between requests for updated SNTP
63