D-Link DGS-3324SRi User Manual page 101

D-Link DGS-3324SRi Intelligent Stackable Gigabit Ethernet Switch
An example is presented below:
VLAN Name
System (default)
Engineer
Marketing
Finance
Sales
Backbone
In this case, 6 IP interfaces are required, so a CIDR notation of 10.32.0.0/11 (or a 11-bit) addressing scheme will
work. This addressing scheme will give a subnet mask of 11111111.11100000.00000000.00000000 (binary) or
255.224.0.0 (decimal).
Using a 10.xxx.xxx.xxx IP address notation, the above example would give 6 network addresses and 6 subnets.
Any IP address from the allowed range of IP addresses for each subnet can be chosen as an IP address for an IP
interface on the switch.
For this example, we have chosen the next IP address above the network address for the IP interface's IP
Address:
VLAN Name
System (default)
Engineer
Marketing
Finance
Sales
Backbone
The 6 IP interfaces, each with an IP address (listed in the table above), and a subnet mask of 255.224.0.0 can be
entered into the Setup IP Interface window.
To setup IP Interfaces on the Switch:
Go to the Configuration folder, and click on the Layer 3 IP Networking folder, and then click on the IP
Interfaces Table link to open the following dialog box:
VID
1
2
3
4
5
6
Table 4- 2. VLAN Example – Assigned Ports
VID
1
2
3
4
5
6
Table 4- 3. VLAN Example – Assigned IP Interfaces
Switch Ports
5, 6, 7, 8, 21, 22, 23, 24
9, 10, 11, 12
13, 14, 15, 16
17, 18, 19, 20
1, 2, 3, 4
25, 26
Network Number IP Address
10.32.0.0 10.32.0.1
10.64.0.0 10.64.0.1
10.96.0.0 10.96.0.1
10.128.0.0 10.128.0.1
10.160.0.0 10.160.0.1
10.192.0.0 10.192.0.1
86