D-Link DGS-3324SRi User Manual page 37

D-Link DGS-3324SRi Intelligent Stackable Gigabit Ethernet Switch
Multicast Router
Only
GVRP Status
Telnet Status
Web Status
RMON Status
Link Aggregation
Algorithm
Switch 802.1x
Auth Protocol
HOL Prevention
Jumbo Frame
Syslog State
If this option is enabled and IGMP Snooping is also enabled, the Switch
forwards all multicast traffic to a multicast-enabled router only. Otherwise,
the Switch will forward all multicast traffic to any IP router.
Use this pull-down menu to Enable or Disable GVRP on the Switch.
Telnet configuration is Enabled by default. If you do not want to allow
configuration of the system through Telnet choose Disabled.
Web-based management is Enabled by default. If you choose to disable
this by selecting Disabled, you will lose the ability to configure the system
through the web interface as soon as these settings are applied.
Remote monitoring (RMON) of the Switch is Enabled or Disabled here.
The algorithm that the Switch uses to balance the load across the ports
that make up the port trunk group is defined by this definition. Choose
Source Address, Destination Address or Both. (See Link Aggregation).
Enables or disables 802.1x; default is Disabled.
The user may choose between Local and Radius Eap.
Enables or disables HOL (Head of Line) prevention; default is Enabled.
Enables or disables Jumbo Frame acceptance; default is Disabled.
Enables or disables Syslog State; default is Disabled.
22