Final Drive Installation - Honda NSA700A DN-1 2009 Service Manual

Apply locking agent to the threads of the case cover
10 mm bolts.
Install the bolts, and tighten them in a crisscross
pattern in several steps until the cover evenly
touches the gear case.
Tighten the two 10 mm bolts to the specified torque
in several steps alternately.
TORQUE: 47 N-m (4.8 kgf-m, 35 Ibf-ft)
Tighten the six 8 mm bolts to the specified torque in
a crisscross pattern in several steps.
TORQUE: 25 N-m (2.6 kgf-m, 19 Ibf-ft)
Check that the gear assembly turns sm oothly w ith ­
out binding.
Measure the final gear assembly preload.
STANDARD:
0.3 - 1.1 N-m (0.03 - 0.11 kgf-cm, 0.2 - 0.8 Ibf-ft)
If the preload reading does not fall w ithin the speci­
fication, check the bearings fo r proper installation.

FINAL DRIVE INSTALLATION

Check that the gear case stud bolts are tight.
If any are loose, remove them, clean their threads
with contact cleaner, then insta I them using a lock­
ing agent.
After installing, be sure to measure the distance
from the top of each stud to the gear case surface as
shown.
Install a new stopper ring into the drive shaft
groove.
Install the spring into the drive shaft.
Apply 5 g (0.2 oz) of molybdenum disulfide grease
to a new oil seal lips and install it onto the drive
shaft.
8 mm BOLTS
STOPPER RING
OIL SEAL
FINAL DRIVE
-OlTOI
10 mm BOLTS
GEAR CASE COVER
SPRING
14-21