Service Rules; Abbreviation - Honda NSA700A DN-1 2009 Service Manual

Table of Contents

Advertisement

GENERAL INFORMATION

SERVICE RULES

1. Use Honda Genuine or Honda-recommended parts and lubricants or their equivalents. Parts that don't meet Honda's
design specifications may cause damage to the motorcycle.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing the motorcycle. Metric bolts, nuts and screws are not interchangeable with
English fasteners.
4. Install new gaskets, O-rings, cotter pins, and lock plates when reassembling.
5. When tightening bolts or nuts, begin with the larger diameter or inner bolt first. Then tighten to the specified torque
diagonally in incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all electrical wires as shown in the Cable and Harness Routing (page 1-20).
9. Do not bend or tw ist control cables. Damaged control cables w ill not operate sm oothly and may stick or bind.

ABBREVIATION

Throughout this manual, the follow ing abbreviations are used to identify the respective parts or systems.
Abbrev. term
ABS
CKP sensor
CMP sensor
DLC
DTC
ECM
ECT sensor
EEPROM
EOP switch
HFTOP sensor
EOT sensor
EVAP
HDS
IACV
IAT sensor
MAP sensor
MIL
N/D clutch
N/D select switch
N/D solenoid valve
PAIR
PGM-FI
SCS connector
TCM
TP sensor
VS sensor
1-2
Anti-lock Brake System
Crankshaft Position sensor
Camshaft Position sensor
Data Link Connector
Diagnostic Trouble Code
Engine Control Module
Engine Coolant Temperature sensor
Electrically Erasable Programmable Read Only Memory
Engine Oil Pressure switch
HFT Oil Pressure sensor
Engine Oil Temperature sensor
Evaporative Emission
Honda Diagnostic System
Idle A ir Control Valve
Intake A ir Temperature sensor
Manifold Absolute Pressure sensor
Malfunction Indicator Lamp
Neutral/Drive clutch
Neutral/Drive select switch
Neutral/Drive solenoid valve
Pulsed Secondary A ir Injection
Programmed Fuel Injection
Service Check Short connector
Transmission Control Module
Throttle Position sensor
Vehicle Speed sensor
Full term

Advertisement

Table of Contents
loading

Table of Contents