Laser Unit - Sharp MX-C382SC Operation Manual

8
9
Holes to be cleaned
There are a total of 4 holes to be cleaned in the laser unit.
If the cleaner becomes dirty during cleaning, replace with a new cleaner. For the procedure for replacing the cleaner,
see steps 5 to 7.
(1)
10
(3)
(A)
Boss
(2)
1-72
BEFORE USING THE MACHINE
Clean the laser unit.
(1) Point the cleaner down and slowly insert
the tool into the hole that you wish to clean.
The parts of the writing unit that require cleaning are
indicated by labels similar to (A).
(2) Insert the cleaning tool all the way into the
hole and then pull it back out.
Pull the cleaning tool out until you feel the tip of the tool
leave the cleaning surface of the laser unit.
(3) Repeat step (2) two or three times and then
remove the cleaning tool.
Repeat step 8 to clean all holes in the

laser unit.

Replace the cleaning tool.
(1) Rotate the cleaning instrument after putting
it on the boss and hook its edge (the side
where the cleaner is fixed) to the claw on
the left side.
(2) Place the right-hand side of the cleaning
instrument on the front side, spread across
the top of the claw.
(3) Hook the cleaning instrument to the claw.
Contents