Placement Of Document Scanner Unit In Position For Transportation (Function Code 06); Adf Performance Test (Function Code 08) - Konica Minolta bizhub 20 Service Manual

4.3 Placement of Document Scanner Unit in Position for Transportation
(Function code 06)
<Function>
This function is to move the document scanner unit in position for transportation located at
the left end.
When you fix the FAX equipment and check its operation, you need to perform this function
right before packing and shipping it.
Note:
• Please instruct end users to perform this function if possible before packing and
shipping their FAX equipment to a sales agent or a service dealer for the purpose of
repair. (For the procedure to allow users to perform maintenance modes, please
see Section
<Operating Procedure>
(1) Press the [0] and [6] keys in this order in the initial stage of the maintenance mode.
The CCD unit moves to the designated position for transportation located at the left end.
The "MAINTENANCE 06" is displayed until the CCD unit is placed in position.
When the CCD unit is placed in the position, the "PLEASE SCAN LOCK" appears on the
LCD.
(2) Open the document cover, and lock the scanner lock lever at the rear left of the
document scanner unit. When the scanner lock lever is locked, the "SCAN LOCKED"
appears.
To terminate this operation, press the [Stop/Exit] button. The machine returns to the
initial stage of the maintenance mode. The machine will be unable to scan after this
operation until switch OFF/ON is pressed or the "Function 99" is performed.
4.4

ADF Performance Test (Function code 08)

<Function>
The machine counts the documents fed by the automatic document feeder (ADF) and
displays the count on the LCD for checking the ADF performance.
<Operating Procedure>
(1) Set documents. (Allowable up to the ADF capacity.)
The "DOC. READY" will appear on the LCD.
(2) Press the [0] and [8] keys in this order.
Press the [
While counting the documents, the machine feeds them in and out, displaying the
current count on the LCD as shown below.
ADF CHECK P.01
(3) Press the [Stop/Exit] button, then the operation of the above will finish and return the
machine to the initial stage of the maintenance mode.
3.)
] or [ ] buttons so that the "[
Current count (1st page in this example)
]: DX, [ ]: SX" is displayed on the LCD.
6-8
Confidential