Installing The Anti-Tippers; Removing/Installing The Rear Wheels - Invacare 9000 SL Owner's Operator And Maintenance Manual

PROCEDURE 10
BACK VIEW OF 9000XT RECLINER
R
E
C
Spreader
L
Bar
I
Recliner
N
Tube
E
R
FIGURE 6 - STORING THE SPREADER BAR
Replacing (FIGURE 7)
1. Unthread both locking knobs that secure the
spreader bar to the side frames.
2. Remove existing spreader bar.
3. Secure NEW spreader bar to the side frames
with the existing locking knobs. Securely tighten.
Locking
Knobs
Side
Frame
FIGURE 7 - REPLACING THE SPREADER BAR

INSTALLING THE ANTI-TIPPERS

(FIGURE 8)
1. Press the release buttons IN and insert the anti-
tippers with the anti-tipper wheels pointing to-
ward the ground/floor into the rear frame tubing
until the bottom release button locks in place.
Side
Frame
Spreader
Bar
Side
Frame
34
Release Rear
Buttons Frame
Tubing
Anti-tipper
Wheels
Anti-tipper
FIGURE 8 - INSTALLING THE ANTI-TIPPERS
REMOVING/INSTALLING THE REAR
WHEELS
NOTE: If replacing the same size rear wheel, this
procedure may be performed.
WARNING
If changing the size of the rear wheel or a change
in the SEAT-TO-FLOOR HEIGHT is desired, this
procedure must be performed by an authorized
Invacare dealer or qualified technician.
With Patient Operated Wheel Locks (FIGURE 9)
1. Remove the axle mounting screw and locknut that
secure the patient operated wheel lock, spac-
ers, and rear wheel to the wheelchair frame.
2. Secure rear wheel, patient operated wheel lock,
and spacers to wheelchair frame with axle mount-
ing screw and locknut. Securely tighten.
Wheelchair Frame
Locknut
Spacers
Rear
Wheel
FIGURE 9 - REMOVING/INSTALLING THE REAR
WHEELS - WITH PATIENT OPERATED WHEEL
LOCKS
RECLINER
Patient Operated
Wheel Lock
Axle
Mounting
Screw