Replacing Dual Point Arm Pad/Clothing Guards; Replacing Arm Pad; Replacing Clothing Guards; Installing/Removing T-Arms - Invacare XtraTM 1026793 Operator And Maintenance Manual

Replacing Dual Point Arm Pad/Clothing Guards

NOTE: For this procedure, refer to FIGURE 7.4.

Replacing Arm Pad

1. Remove the phillips screws that secure
the arm pad to the armrest assembly.
2. Replace arm pad and securely tighten
with the existing phillips screws.

Replacing Clothing Guards

NOTE: This procedure is for fixed height dual
point arms ONLY.
1. Remove the four (4) screws that secure
the existing clothing guard to the
armrest assembly.
2. Replace the existing clothing guard
with the new clothing guard and
securely tighten with the existing
hardware.
3. Repeat STEPS 1-2 for the opposite side
if necessary.

Installing/Removing T-Arms

NOTE: For this procedure, refer to FIGURE 7.5.

Installing T-Arms

1. Position the T-arm over the T-arm socket on the wheelchair frame.
NOTE: Make sure the locking lever is towards the front of the wheelchair.
2. Slide T-arm into T-arm socket until the locking lever is in the slot in the T-arm socket
and an audible "click" is heard.
3. Pull up on T-arm to make sure T-arm is locked in place.
NOTE: If the T-arm does not slide in the T-arm socket as desired, adjust the T-arm socket. Refer to
Adjusting the T-Arms on page 46.
4. Adjust the T-arm for desired height, width and depth, if necessary. Refer to Adjusting
the T-Arms on page 46.
5. Repeat STEPS 1-4 for opposite side of wheelchair.
Part No 1026793
Screws
Clothing
Guards
Screws
FIGURE 7.4 Replacing Dual Point Arm Pad/
Clothing Guards
45
SECTION 7—ARMS
Arm Pad
Armrest
Assembly
Phillips
Screws
Xtra™