Power Connector Cable - HP Pavilion x360 Convertible Maintenance And Service Manual

Power connector cable

Description
Power connector cable
Before removing the power connector cable, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the top cover (see
5. Remove the system board (see
6. Remove the display (see
Remove the power connector cable:
1. Remove the Phillips PM2.0×2.0 screw (1) that secures the bracket to the computer.
2. Remove the bracket from the computer (2).
3. Pull the connector out from under the rear corner of the computer (3).
4. Remove the power connector cable.
Reverse this procedure to install the power connector cable.
Top cover on page 29).
System board on page
Display assembly on page
43).
55).
Component replacement procedures
Spare part number
807522-001
63