Table of Contents
Advertisement
Software Installation
Selecting a driver for a SCSI controller
To select a driver for the SCSI controller:
1
When the Windows NT Server 4.0 Setup Disk 2 displays a message asking whether
or not to detect large capacity storage devices, select "S=Skip Detection."
If you are booting from the Windows NT Setup CD-ROM, press F6 when the
following message appears on the DOS screen:
"Setup is inspecting your computer's hardware configuration."
2
Select "S=Specify Additional Device."
3
Select "Others (Requires disk provided by a hardware manufacturer)."
4
Insert the Adaptec 7800 Family Manager Set v3.03 backup floppy disk, created
above, in the diskette drive. Press the Enter key.
5
In the next displayed window, select "Adaptec AHA-294XU2/295XU2/395XU2/AIC-
789XPCI SCSI Controller (NT 4.0)."
Selecting a driver for a RAID controller
To select a driver for the RAID controller:
1
When the Windows NT Server 4.0 Setup Disk 2 displays a message asking whether
or not to detect large capacity storage devices, select "S=Skip Detection."
If you are booting from the Windows NT Setup CD-ROM, press F6 when the
following message appears on the DOS screen:
"Setup is inspecting your computer's hardware configuration."
2
Select "S=Specify Additional Device."
3
Select "Others (Requires disk provided by a hardware manufacturer)."
4
Insert the floppy disk labeled "MegaRAID Driver & Utilities for Series 466 Windows
NT/Power Console" (supplied with the RAID controller) into the floppy disk drive, and
press the Enter key.
5
In the next displayed window, select "MEGARAID NT SCSI Driver."
Selecting a driver for the network adapter
To select a driver for the network adapter:
1
When a message appears in the Windows NT Setup window "Installing Windows NT
Networking," prompting you to select between "Remote Access to the Network" and
"Wired to the Network," select "Wired to the Network," mark the "Connect to the
Network" checkbox, and click "Next."
Installing Windows NT Server 4.0
93
Advertisement
Table of Contents
