Table of Contents
Advertisement
System Configuration Setup
CYLS
HEADS
PRECOMP
LANDZONE
SECTORS
If a hard disk has not been installed, select NONE and press Enter.
❖
Drive A type/ Drive B type - Identifies the type of floppy disk drive A or drive B that has
been installed in the server.
None
360K, 5.25-in.
1.2M 5.25-in.
720K 3.5-in.
1.44M 3.5-in.
(default)
2.88M 3.5-in.
❖
Floppy 3 Mode Support - Specifies the storage formats supported by the floppy disk
drive—720 KB, 1.2 MB, and 1.44 MB.
Disable
(default)
Drive A
Drive B
Both
❖
Virus Warning - When set to Enable, the system will halt and display a warning
message if there is any attempt to access the boot sector or partition table of the hard
disk drive. You can run an anti-virus program to locate the problem.
Enable
Disable
(default)
Number of cylinders
Number of heads
Write precomp
Landing zone
Number of sectors
No floppy disk drive installed
5.25 inch PC-type standard drive; 360 KB
capacity
5.25-inch AT-type high-density drive; 1.2 MB
capacity (3.5-inch when 3 Mode is enabled)
3.5-inch double-sided drive; 720 KB capacity
3.5-inch double-sided drive; 1.44 MB capacity
3.5-inch double-sided drive; 2.88 MB capacity
Normal floppy disk drive(s).
Drive A is 3 mode floppy disk drive
Drive B is 3 mode floppy disk drive
Drives A and B are 3 mode floppy disk drives
Activates automatically when the system
boots up causing a warning message to
appear when anything attempts to access the
boot sector or hard disk partition table
No warning message appears when anything
attempts to access the boot sector or hard
disk partition table
74
Setup
Advertisement
Table of Contents
