IBM eServer 130 xSeries User Reference Manual page 75

6. Install the DIMM in the connector.
Attention: To prevent damage to the DIMM connectors, do not force the
memory module into the connector.
a. Turn the DIMM so that the index slots align correctly with the connector.
Note: The DIMM has two index slots, one in the center and the other on the
left half of the DIMM connector edge.
b. Insert the DIMM into the connector by pressing on both corners of the DIMM
at the same time. Be sure to press straight into the connector.
Note: When installing a memory module, be sure that no gap exists between
the DIMM and the retaining clips. If a gap does exist between the
memory module and the retaining clips, remove the DIMM; then,
reinsert the DIMM properly.
Attention: To avoid breaking the retaining clips or damaging the DIMM
connectors, handle the clips gently.
7. If you removed the adapter from PCI slot 2, reinstall it.
Note: When you start the appliance server for the first time after adding memory,
you must have a keyboard, monitor, and mouse connected to the
appliance server. The system displays a message indicating that the
memory configuration has changed.
• If you installed additional memory, start the Configuration/Setup Utility
program, and select Save Settings. For more information see "Using
the Configuration/Setup Utility program for the xSeries 130" on page
22.
• If you just replaced a failed DIMM, you must start the
Configuration/Setup Utility program, select Advanced Setup, select
Memory Settings, highlight the connector or bank of connectors that
you want to enable, and then select Enable.
8. If you have other options to install, install them now. Otherwise, go to "Installing
the cover" on page 68.
Chapter 6. Installing options
61