IBM eServer 130 xSeries User Reference Manual page 108

Table 14. POST error messages.
POST message
00180600 A PCI-to-PCI bridge error occurred. More than one PCI bus tried to access memory below 1 MB.
Action: Remove the PCI adapter that has the PCI bridge. If you can start the appliance server
If you cannot isolate and correct the problem, call for service.
00180700 xxxxyyyy system board PCI device does not respond or was disabled by the user (where xxxx is
the PCI vendor ID and yyyy is the PCI device ID).
Action: Start the Configuration/Setup Utility program, select Devices and I/O Ports, and make
00180800 An unsupported PCI device is installed.
Action: Remove the PCI adapters. If you can start the appliance server without the adapters,
If the problem persists, call for service.
00181000 PCI error.
Action: Remove the PCI adapters. If you can start the appliance server without the adapters,
If the problem persists, call for service.
01295085 The ECC checking hardware test failed.
Action: Call for service.
01298001 No update data is available for processor 1.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
01298002 No update data is available for processor 2.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
01298101 The update data for processor 1 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
01298102 The update data for processor 2 is incorrect.
Action: Update the system BIOS to a level that supports the microprocessors that are installed in
01298200 Microprocessor speed mismatch
Action: The microprocessors that are installed do not run at the same speed; install
I9990301 A hard disk drive error occurred.
Action: Call for service.
I9990305 POST could not find an operating system.
Action: Install an operating system. If you have already installed the operating system, check the
If you cannot reinstall the operating system, call for service.
94
IBM xSeries 130: User's Reference
without the adapter, reinstall and retest the adapter. If the adapter fails, replace it.
sure that the device is enabled. If the problem persists, call for service.
reinstall each adapter one at a time and retest after each is reinstalled. When an adapter
fails, replace it.
reinstall each adapter one at a time and retest after each is reinstalled. When an adapter
fails, replace it.
the appliance server.
the appliance server.
the appliance server.
the appliance server.
microprocessors with identical speeds.
drive startup sequence. If the drive sequence is correct, run the diagnostic tests to verify
that the hard disk drive is functioning correctly. If there is a problem with the hard disk
drive (such as a bad sector), you might need to reinstall the operating system.
Description