IBM eServer 130 xSeries User Reference Manual page 132

1. Write down the model number and serial number of your appliance server. This
2. Select a one-U size location in the rack cabinet. Install a cage nut or clip nut in the
3. Adjust each rear mounting bracket (by loosening the screws) so that the inside
4. Loosely install two mounting screws through the back end of the bracket. Position
118
IBM xSeries 130: User's Reference
information is found on the right side of the bezel on the front corner. You need
this information for connecting the appliance server to the network.
top and bottom position of the one-U location that you selected (both sides, front
and rear of the rack cabinet).
Clip
nuts
distance between the two ends is equal to the outside dimension of the rack
mounting flanges. Insert the bracket tab through the center hole between the two
clip nuts on the rear mounting flanges. (The right and left rails are labeled.)
Mounting bracket
Rack
Clip nuts
Tab
the mounting bracket so that it lines up with the clip nuts. Install the remaining
mounting screws; then, tighten all the screws with a screwdriver. Repeat these
steps for each mounting bracket.
Cage
nuts
Cage
nuts
Screws
Adjustable
bracket