Balancer Shaft And Balancer Shaft Driven Gear - Suzuki GZ250 Service Manual

3-39 ENGINE

BALANCER SHAFT AND BALANCER SHAFT DRIVEN GEAR

DISASSEMBLY
• Disassemble the balancer shaft as shown in the illustration.
Balancer shaft
Key
Balancer shaft driven
gear Spring (6 pcs.)
Pin (3 pcs.)
INSPECTION
Inspect the balancer shaft and balancer shaft driven gear
for wear or damage. If any wear or damage is found, re-
place the defective part.
Measure the free length of each balancer spring using ver-
nier calipers. If any spring is not within the service limit,
replace all of the spring.
09900-20101: Vernier calipers
Service Limit: 10.0 mm (0.39 in)
REASSEMBLY
Reassemble the balancer shaft driven gear in the reverse
order of disassembly. Pay attention to the following points:
• Make sure that the punch mark
aligned with the punch mark
driven gear.
: Pin
on the inner race is
on the balancer shaft