Reassembly; Remounting - Suzuki GZ250 Service Manual

4-9 FUEL A ND LUBRICA TION SYSTEM
FLOAT HEIGHT ADJUSTMENT
To check the float height, turn the carburetor upside down.
Measure the float height
tacting the needle valve using vernier calipers. Bend the
tongue as necessary to bring the float height
specified value.
Float height : 13.0 ±0.5 mm (0.51 ±0.02 in)
09900-20101: Vernier calipers

REASSEMBLY

Reassemble the carburetor in the reverse order of disas-
sembly.
Pay attention to the following points: • Turn the throttle
stop screw until the throttle valve's bottom end is
aligned with the foremost by-pass port
NOTE:
When removing the throttle valve, applying a small quantity
of THREAD LOCK "1342" to the throttle valve mounting
screws and tighten them.
99000-32050: THREAD LOCK "1342"
A CAUTION
Face the stamped side of the throttle valve out.
• Install the needle jet as shown.
Large diameter side Bore
side
Small diameter side
Main jet side

REMOUNTING

Remount the carburetor in the reverse order of removal.
* Adjust the following items to the specification.
* Engine idle r/min ............................See pp. 2-7 and -8.
* Throttle cable play ..................................... See p. 2-8.
* Starter plunger cable play ........................ See p. 2-9.
while the float arm is just con-
to the