Table of Contents
Advertisement
System Configuration Setup
Boot Channel: A First
Selects the SCSI controller which boots the system. Do not change this setting.
Boot SCSI ID: 0
Selects the SCSI ID of the device which boots the system. Do not change this
setting.
Boot LUN Number: 0
Selects the LUN of the device which boots the system. Do not change this setting.
SCSI Device Configuration
Specifies detailed configuration information for each SCSI device (SCSI ID).
Sync Transfer Rate (MB/Sec): 160
Specifies the maximum synchronous transfer rate of the onboard SCSI controller.
Initiate Wide Negotiation: Yes
Set this item to Yes to specify Wide SCSI (16 bit data width).
Enable Disconnection: Yes
Set this item to Yes to make the adapter activate the disconnect/reconnect
function and permit multiple-command processing.
Send Start Unit Command: Yes
Specifies whether a start unit command is to be sent from the adapter to start the
SCSI device.
Enable Write-Back Cache: N/C
Specifies whether to use the write-back cache.
BIOS Multiple LUN Support: No
Specifies whether logical unit numbers are supported.
Include in BIOS Scan: Yes
Specifies whether the device is to be scanned when SCSI BIOS starts.
Advanced Configuration Options
Sets up detailed data on the SCSI controller.
Using the Adaptec SCSI Utility
96
Advertisement
Table of Contents
