Sliding The Server From The Rack; Sliding The Server Into The Rack - Toshiba Magnia 3135R User Manual

Connecting Hardware Devices

Sliding the Server From the Rack

CAUTION: If the rack contains additional servers that are currently in use, be
careful not to touch the hard disk drive eject lever or AC switch on those servers.
1 Make sure that the cables connected to the server are long enough to allow the
server to be extended from the rack. If the cables are too short, disconnect them to
avoid damaging the cables or the server.
2 Loosen the two thumbscrews securing the server to the rack.
3 Grasp the handles on the server's front panel, then carefully slide the server from
the rack.
4 Continue sliding the server from the rack until the rail latches lock the server in its
fully-extended position.
Sliding the server from the rack
5 To ensure that the server is locked in position, using light pressure, try to slide the
server back into the rack.

Sliding the Server into the Rack

1 Press the rail latches inward to release the server from its locked position then slide
the server into the rack.
2 Tighten the two thumbscrews on the front panel to secure the server to the rack.
3 Reconnect any cables that were disconnected from the server.
52
Maintenance Overview