Selecting A Region To Copy, Cut Or Delete; Setting Editing Start Points; Setting Editing End Points; Clearing Editing Start And End Points - Tascam HS-4000 Owner's Manual

7 – Timeline mode

Selecting a region to copy, cut or delete

• If editing start and end points have been set, the region
between these points is selected.
• If editing start and end points have not been set, the entire
region where the time cursor is located in the current track
is selected.
Editing start and end points not set
• If the timeline cursor is located at the border between
regions, the region to its right will be subject to the editing.
If that region is silent, however, it will remain unselected.

Setting editing start points

1. Press the HOME key on the front panel to open the Home
Screen.
2. Touch the EDIT MODE button to enter editing mode.
3. Use them/, keys, for example, to locate the timeline
cursor to the position (time) where you want to start editing.
4. Touch the IN/OUT button to open a pull-up menu.
5. Touch the SET IN button in the pull-up menu to set the
editing start point (IN point).
The IN mark ( ) appears at the current position in the mark
display area.
58
TASCAM HS-4000

Setting editing end points

1. Use them/, keys, for example, to locate the timeline
cursor to the position (time) where you want to end editing.
2. Touch the IN/OUT button to open a pull-up menu.
3. Touch the SET OUT button in the pull-up menu item to set
the editing end point (OUT point).
The OUT mark ( ) appears at the current position in the
mark display area.
The interval between the IN ( ) and OUT ( ) marks, which is
shown in blue, will be subject to editing.

Clearing editing start and end points

1. Touch the IN/OUT button to open a pull-up menu.
2. Touch the CLEAR button on the pull-up menu to discard the
currently set IN and OUT points.
When a confirmation message pop-up appears, touch the
OK button or press the DATA dial. The IN ( ) and OUT ( )
marks in the mark display area will disappear.