Tascam HS-4000 Owner's Manual page 17

The number shown when searching
forward (shuttle operation) changes with
the current speed: x2, x4, x8, x16, x32.
Recording
Recording standby
Touch this area to open the PLAY SETUP screen.
Session name (button)
9
This shows the currently active session name. A "*" appears
when the session has not been saved after editing (including
the addition and removal of session editing marks).
Touch this area to open a pull-down menu.
START TIME EDIT button
This opens the START TIME screen where you can set the
timeline mode starting time. This can only be selected when
stopped.
REBUILD button
Use to rebuild when, for example, a file has been erased
from the unit using FTP.
This can only be selected when stopped.
SAVE button
This saves the contents of the timeline.
This can only be selected when stopped.(See "Saving
timelines" on page 56.)
EXPORT AES31 button
This outputs (exports) the session as an AES31 file. This
can only be selected when stopped.(See "Exporting AES31
editing information" on page 55.)
IMPORT ALL TAKES button
Touch to import all session takes.
This can only be selected when stopped.(See "Importing all
takes" on page 56.)
Track numbers and record function and input
0
monitoring indicators
The indicators at the left end of the level meters show
the status of record arming and input monitoring. The
background colors of the indicators mean the following.
REC OFF
MON OFF
MON ON
Level meters
q
The input signal level for a track is shown if input monitoring
for it is set to ON or if it is armed for recording and not
playing back. Each track also has an overload indicator at its
right end that appears red when the input overloads.
During playback, the playback level of a track is shown if
input monitoring is set to OFF.
When the input source is set to a digital input, but there is
no input signal or if the input signal differs from the internal
2 − Names and functions of parts
w
REC ON
setting, the channel meter display area appears gray and
one of the following messages appears. (The "x" indicates
the channel.)
Display Meaning
D-INx NO SIGNAL No input signal
Input signal is not synchronized
D-INx UNLOCK
with the system
Cbit information of the input
D-INx NOT AUDIO
signal is not audio
Other input signal Cbit infor-
D-INx Cbit ERROR mation differs from the actual
operation mode
D–IN1 UNLOCK shown
The following settings can be made for the display of the
level meters on the METER SETUP screen from the MENU
screen.
o Metering point
o Peak hold time
o Release time
o Overload indicator peak level
o Reference level line display on/off
You can also touch these areas to output just one pair of
channels (1-2 or 3-4) for monitoring (solo function).
The level meters and track numbers for the soloed channels
appear highlighted in yellow.
The level meters for the channels that are not soloed appear
shaded. Touch the same channel pair again to stop soloing
them.
Time display area
When the time display mode has been set to show a
timeline with four equal divisions, four times are shown.
This area has 4 equal divisions, showing 4 time points on the
timeline.
The values match the time display mode.
17
TASCAM HS-4000