Tascam HS-4000 Owner's Manual page 19

BOUNCE I/O button
a
Touch this button to open a pull-up with buttons related to
bouncing.
Bounce button
Touch this button to bounce. In the following circumstances,
this button appears gray and cannot be used.
o When both starting (IN) and ending (OUT) points have
not been set
o During playback or recording
o When "TIMELINE Rec Tracks"is set to "2trx2" and no
track is selected
SET IN button
Touch to set the current position as the bounce starting (IN)
point.
SET OUT button
Touch to set the current position as the bounce ending
(OUT) point.
CLEAR button
Touch to discard the currently set bounce starting (IN) and
ending (OUT) points.
For details about these buttons, see "Bouncing" on page
67.
NEXT TAKE NAME button
s
Touch this button to open the NEXT TAKE NAME page where
you can set the name that will be given to takes or files
recorded in the future.
First half of take names
The first half of the take name can be set to either the User
Word or the Session Name (default).
CAUTION
The first half of the take name can only be changed when
the unit is stopped.
"User Word" mode (button)
Use the user word for the first half of the take name.
Press the EDIT button to open the screen where you can
change the user word. (This works the same as the screen for
editing project names.)
2 − Names and functions of parts
"Session Name" mode (button)
Use the session name as the first half of the take name.
Second half of take names
The second half of the take name is comprised of one alpha-
betical letter and a three-digit number.
Press the EDIT button to open the screen where you can
change the letter.
You can change the three-digit number with the + and –
buttons. You can also touch the numerical part to highlight
it in yellow and use the DATA dial to change the number.
In the following cases, "---" appears and the value cannot be
changed.
o No project or session is loaded
o The selected CF card is unavailable
o When the numerical part of the file name of the
current take is 999
CAUTION
• The Next Take Name setting is saved with each project. If
you change projects, the setting of the loaded project is
used.
• The number in the second half of the take name can also
be changed during playback or recording. (The first half of
the take name and the letters in the second half can only be
edited when stopped.)
NOTE
If the first half of the take name or the letter in the second
half is different, a take that has the same three-digit number
in the second half can be created.
INFO button
d
Touch this button to open an information display that shows
the current settings of the unit and information about the
loaded file.
The upper section shows the current settings of this unit.
Touch this area to open the SYNC T/C screen.
The lower section shows information about the currently
loaded session. Touch this area to open the project screen.
The name of the previous mark most recently passed or at
the current time is shown on the right. When the name of a
mark other than an automatic mark is shown, touch this area
to open the MARK NAME editing screen.
19
TASCAM HS-4000