Playlist Playback; Using The Call Function; Bwf-J Cue Points (Playlist Mode); Using The Flash Start Function - Tascam HS-4000 Owner's Manual

Playlist playback

Press the PLAY key to start playback.
Press the PAUSE key to enter playback standby.
To end playback standby, press the PLAY key.
Press the STOP (RETAKE) key to stop playback.
Press the . [MARK.] key or / [MARK /] key to
switch entries.
Press and hold the m [
search backward or forward.
Press the . [MARK.] or / [MARK /] key while
pressing and holding the SHIFT key to move between marks.
Press and hold the m[ ] or ,[
and holding the SHIFT key to search at high-speed.
NOTE
• On the PLAY SETUP screen, you can set whether only the
currently selected entry is played or whether all the entries
within the current playlist are played. In addition, you can
also turn repeat playback on and off (in single and dual
modes). (See "Online function" on page 35.)
• Playback functions can also be used via parallel control.

Using the call function

Press the CALL (CHASE) key to locate to the point where
playback was last started from playback standby (call point) and
put the unit in playback standby mode.
] key or , [ ] key to
] key while pressing
9 – Playlist mode

BWF-J cue points (playlist mode)

When the Follow BWF-J item is set to ON, if a BWF-J cue point
is detected during playback, the following corresponding
operation will occur. In addition, if the BWF-J Tally item is set to
ON and the unit is in single player mode, in response to each
BWF-J cue point, the CUE signal and tally signal will be output
from the parallel remote connector.
When an entry is selected, this point is
made the playback starting position.
BC$STANDBY During playback, when this point is
reached, playback standby starts. In either
case, a BC$STANDBY tally is output.
During playback, when this point is
BC$CM
reached, a BC$CM CUE signal is output.
During playback, when this point is
BC$END
reached, a BC$END CUE signal is output.
During playback, when this point is
BC$STOP reached, a BC$STOP CUE signal is output,
and playback stops.
During playback, when this point is
reached, a BC$END cue signal is output
and if the next take has a BC$STANDBY cue
BC$FILE
point, the transport locates to that point,
playback standby starts and a BC$STANDBY
tally is output.
During playback, when this point is
BC$PAUSE reached, a BC$PAUSE tally is output, and
playback standby starts.

Using the flash start function

Using a TASCAM RC-HS32PD (sold separately) or other remote
controller, flash start playback is possible. For details, see "Flash
start function" on page 123.
Flash start key display colors on the TASCAM
RC-HS32PD remote control in A/B MIXED
mode
In the same manner that the icons in the entry name buttons
on the entry list screen and the key assign list buttons on the
file assign screen are classified by color, the TASCAM RC-HS32PD
remote control flash start keys will have the following display
colors.
Playing
Output Stopped
back
A Orange Green
Darker
B Purple
blue
No
Playback Invalid
assigned
standby entry
entry
Orange
Red Unlit
blinking
Purple
Red Unlit
blinking
97
TASCAM HS-4000