Table of Contents
Advertisement
4.2.26 Factory Default
You can reset the configuration of the stack switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
Buttons
: Click to reset the configuration to Factory Defaults.
: Click to return to the Port State Page without resetting the configuration.
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
4.2.27 System Reboot
The Reboot page enables the device to be rebooted from a remote location. Once the Reboot button is pressed, user will
re-access the WEB interface about 60 seconds later, the System Reboot screen in
Figure 4-2-31: Factory Default Page Screenshot
Figure 4-2-32: System Reboot Page Screenshot
84
User's Manual of MGSW-MGSD Series
Figure 4-2-31
Figure 4-2-32
appears.
appears.
Advertisement
Table of Contents
