Variable Loading Floor In The Luggage Compartment (Estate) - Skoda 2013 Roomster Owner's Manual

Removing the net partition
›
Undo the belts on both sides and unhook the carabines
›
Push the cross rod first of all on the one side and then on the other side to-
wards the rear.
›
Remove the cross rod from the mounts
Packing the net partition
›
Press the red button of the joint
›
Put the net partition folded together in the bag and close it.
›
Attach the bag with the aid of the plastic carabines to the eyes on the left and
right boot trim panel.
Installing and removing the net partition behind the rear seats is carried out anal-
ogously as behind the rear seats. Use the lower fixing eyes on the carrier rails in
order to attach the carabines. To enlarge the boot, the rear seats can be removed.
Installing and removing the net partition behind the rear seats with variable load-
ing floor » page 59 is carried out analogously as behind the rear seats without
variable loading floor. To attach the carabines, use the lower eyes at the fixing
wedges on the front part of the variable loading floor.
The opening » Fig. 49 in the net partition is designed to feed through the
D
three-point seat belt » page 130, Seat belt for the rear middle seat.
Variable loading floor in the luggage compartment
(Estate)

Introduction
This chapter contains information on the following subjects:
Dividing up the luggage compartment with variable loading floor
Removing and refitting the variable loading floor
Removing/installing the carrier rails
Removing/installing the lateral carrier rail and fixing wedges
The variable loading floor makes handling of bulky items of luggage easier.
CAUTION
The maximum permissible load of the variable loading floor is 75 kg.
» Fig. 49.
C
.
B
» Fig. 49- the joint becomes loose.
A
Note
The room under the variable loading floor can be used to stow objects.
Dividing up the luggage compartment with variable loading
floor

First read and observe the introductory information and safety warn-
ings on page 59.

›
Lift up the part with the holder and secure it by sliding it into the grooves
marked with the arrows » Fig.
59
60
60
61
Fig. 50
Dividing the boot
50.
Seats and stowing


59