Modifications, Repairs And Technical Alterations - Skoda 2013 Roomster Owner's Manual

Always clean all parts of the covers, so that there are no visible edges. Then allow
the seat to dry completely.
CAUTION
Regularly remove dust from the seat covers using a vacuum cleaner.
■
Electrically heated seats must not be dried after cleaning by switching on the
■
heater.
Do not sit on wet seats - risk of seat deformation.
■
Always clean the seats "from seam to seam".
■
Seat belts

First read and observe the introductory information and safety warn-
ings on page 149.
The belt webbing must always be kept clean.
Wash dirty seat belts with mild soapy water.
Remove coarse dirt with a soft brush.
Dirty belt webbing may impair the correct functioning of the inertia reel.
WARNING
The seat belts must not be removed for cleaning.
■
Never clean the seat belts chemically as chemical cleaning products could
■
destroy the fabric.
The seat belts must not be allowed to come into contact with corrosive liq-
■
uids (e.g. acids).
Check the condition of all the seat belts on a regular basis. If any damage to
■
the belt webbing, seat belt connections, inertia reel or lock is detected, the
seat belt must be replaced by a specialist garage.
The seat belts must be fully dried before being rolled up.
■

Modifications, repairs and technical alterations


Introduction
This chapter contains information on the following subjects:
ŠKODA Service Partners
Spoiler
Airbags

The instructions and guidelines from ŠKODA AUTO a.s. must be observed when
carrying out all modifications, repairs or technical alterations to your vehicle.
Adhering to these instructions and guidelines helps ensure road safety and helps
keep your vehicle in a good technical condition. After carrying out modifications,
repairs or technical alterations, the vehicle will comply with German road trans-
port regulations (StVZO)
Always consult a ŠKODA Partner
or before carrying out any modifications, repairs or technical alterations to your
vehicle.
WARNING
If work on your vehicle is not carried out properly, this can lead to operation-
■
al faults - risk of accident and serious injuries.
We recommend only having these modifications and technical alterations
■
carried out by a specialist garage.
Interference on the electronic components and their software can lead to
■
operational faults. This interference can also impair not directly affected sys-
tems because of the networking of the electronic components. The operation-
al safety of the vehicle may be at significant risk and can lead to increased
wear of parts.
The ŠKODA Partner does not assume any liability for products that have not
■

been approved by ŠKODA AUTO a.s. even though these may be products with
an operational approval or that have been approved by a government testing
institute.
» page 152 before buying accessories or parts,
Taking care of and cleaning the vehicle
152
152
152

151