Table of Contents
Advertisement
Lock cap
8
Release pin
9
Key
10
Locking ball
11
Note
The tool for removing the wheel trim is part of the vehicle tool kit
■
If you lose the key, please get in touch with a specialist garage.
■
Adjusting the ready position
Fig. 106 Setting the ready position/ready position
First read and observe the introductory information and safety warn-
ings
on page 117.
Always adjust the ball head to the correct position before fitting.
›
Turn the key so that its red mark
›
Grip the ball head below the protective cap
›
Press the release pin
as far as the stop in the direction of the arrow - at the
3
same time push the lever
downwards as far as it will go in the direction of
4
the arrow.
The lever remains locked in this position.
CAUTION
In the ready position, the key cannot be removed nor turned to a different posi-
tion.
118
Driving
» page 177
» Fig. 106
is visible.
1
.
2
Fitting the ball head
.
Fig. 107 Insert the ball head/lock the lock, and put the lock cover on
First read and observe the introductory information and safety warn-
ings
on page 117.
›
Remove the cover in the rear bumper
of the arrow using the tool for removing the wheel trims.
›
Pull off the cover for the mounting recess
tion of the arrow
»
.
›
Adjust the ball head to the ready position
›
Grip the ball head from underneath
cess until it is heard to latch
Lever
» Fig. 107
automatically turns upwards and the release pin
1
(its red and green parts are visible)
If the lever
does not turn automatically, or if the release pin
1
out, remove the ball head from the mounting recess by turning the lever down-
wards as far as it can go. Clean the tapered surfaces on the ball head and the
mounting recess.
›
Lock the lock on the operating lever by turning the key by 180° to the right (see
green marking
is visible) and remove the key in the direction of the arrow.
3
›
Push the cap
» Fig. 107
4
›
Check the ball head for secure mounting
» Fig. 104
on page 117 in the direction
2
» Fig. 104
on page 117 in the direc-
4
» page
118.
» Fig. 107
and insert into the mounting re-
»
.
»
.
onto the lock in the direction of the arrow
» page
119.
pops out
2
does not pop
2
»
.
Advertisement
Chapters
Table of Contents
