Solid State Controller - Frymaster EH1721 Installation & Operation Manual

5. SOLID STATE THERMOSTAT CONTROLLER
5.1 SWITCHES & INDICATORS:
• Power Switch - controls power to the fryer.
• Power On Light - indicates when electrical power is on.
• Temperature Knob - sets desired frying temperature.
• Heat Mode Light - indicates when elements are on (heating).
• Trouble Light - indicates solid state controller system lockout. To reset, turn power switch OFF for 30
seconds, then ON.
• Melt Cycle Switch - controls melt cycle operation.
• Melt Cycle Light - indicates fryer is operating in the melt cycle mode.
5.2 CONTROLLER OPERATION:
a. Ensure the frypot is filled with oil,
shortening, or water.
b. Place the power switch in the ON
position.
c. Set the temperature knob for the desired frying temperature.
CAUTION
Before turning on the solid state controller, the
fryer must be filled with oil, shortening, or water
up to the lower "oil level" line scribed on the
frypot back wall.
15