Manual Basket Lift Timer; Solid-State Basket Lift Timer - Frymaster 47 SERIES Installation, Operation, Service, And Parts Manual

MANUAL BASKET LIFT TIMER

The Manual Basket Lift Timer (shown on the
preceding page) is not a fryer controller. It
only allows the operator to select a cooking
time and initiate independent cooking cycles
for each basket. It is available with the Ther-
mostat Controllers, Analog Controllers, and
Digital Controllers. Computer Magic III and
the Basket Lift Timer control both the basket
lifts and the fryer.
Digital
Display

SOLID-STATE BASKET LIFT TIMER

The Basket Lift Timer allows the operator to
specify individual cooking times for each vat
and independently control the operation of
each basket lift.
Pressing the ON/OFF
electrical power to the fryer components. The
47 SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
Temperature
ON/OFF
Check Button
Button
Cook Time Left
Programming Basket
Buttons Button
BASKET LIFT TIMER
buttons supplies
The cooking time for a basket is specified by
rotating the corresponding timer knob to the
desired time. Pressing the center of the knob
initiates the cooking cycle. The basket will be
automatically lowered into the frypot, and the
timer will begin to count down. When the
timer reaches zero, an alarm buzzer will sound
briefly to alert the operator that the cooking
cycle is completed, and the basket will then be
automatically raised from the frypot. A new
cycle is started by pressing the knob again.
Temperature
ON/OFF
Check Button
Button
Boil-Out Right Cook Time
Button Basket Programming
Button Buttons
fryer will automatically go into the melt cycle
mode if the temperature in the frypot is below
180ºF (82ºC), cycling on for a few seconds
and off for a longer period. The purpose of
the melt cycle is to gradually melt solid short-
ening to prevent its scorching, and to prevent
the creation of "hot spots" in the frypot. To
cancel the melt cycle mode, press the Right
Basket button.
3-13
Digital
Display