Frymaster EH1721 Installation & Operation Manual page 7

4. Insert hex head screws with lock washers (1/4-20 threads by ¾" (19 mm) long) through bolt
holes of leg mounting plates as shown in the Figure 3-1 on the next page. A locknut has been
attached to the top side of the mounting plate at the factory to capture the hex head screw as it is
screwed in.
5. Tighten the bolts and nuts with each bolt to 5.65 joules (50 inch-lbs.) minimum torque.
For caster retrofit, the unit must be at room temperature and drained of shortening before
c. Installing Rear Rigid Casters :
1. Install casters only at the rear of the unit as shown in the Figure 3-1. Legs must be installed at the
front of the fryer.
2. Follow the same instructions for leg installations as given above in steps 3.2.b.1-5.
d. Installing Optional Swivel Casters :
1. Install non-locking casters only at the rear of the unit as shown in the Figure 3-1.
2. Locking casters must be installed at the front of the unit. This allows the fryer to be "locked" in
position for safe operations.
3. Follow the same instructions for leg installations as given above in steps 3.2.b.1-5.
Leg and Caster Installations
Figure 3-1
CAUTION
installing the casters.
6