Mac Filter - ZyXEL Communications p-334whd User Manual

Table 34 Wireless: WPA/WPA2
LABEL
Group Key Update
Timer
Authentication Server
IP Address
Port Number
Shared Secret
Accounting Server
Active
IP Address
Port Number
Shared Secret
Apply
Reset

4.4 MAC Filter

The MAC filter screen allows you to configure the ZyXEL Device to give exclusive access to
up to 32 devices (Allow) or exclude up to 32 devices from accessing the ZyXEL Device
(Deny). Every Ethernet device has a unique MAC (Media Access Control) address. The MAC
address is assigned at the factory and consists of six pairs of hexadecimal characters, for
example, 00:A0:C5:00:00:02. You need to know the MAC address of the devices to configure
this screen.
To change your ZyXEL Device's MAC filter settings, click Network > Wireless LAN >
MAC Filter. The screen appears as shown.
Chapter 4 Wireless LAN
DESCRIPTION
The Group Key Update Timer is the rate at which the AP (if using WPA-PSK/
WPA2-PSK key management) or RADIUS server (if using WPA/WPA2 key
management) sends a new group key out to all clients. The re-keying process is
the WPA/WPA2 equivalent of automatically changing the WEP key for an AP and
all stations in a WLAN on a periodic basis. Setting of the Group Key Update
Timer is also supported in WPA-PSK/WPA2-PSK mode. The ZyXEL Device
default is 1800 seconds (30 minutes).
Enter the IP address of the external authentication server in dotted decimal
notation.
Enter the port number of the external authentication server. The default port
number is 1812.
You need not change this value unless your network administrator instructs you
to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external authentication server and the ZyXEL Device.
The key must be the same on the external authentication server and your ZyXEL
Device. The key is not sent over the network.
Select Yes from the drop down list box to enable user accounting through an
external authentication server.
Enter the IP address of the external accounting server in dotted decimal notation.
Enter the port number of the external accounting server. The default port number
is 1813.
You need not change this value unless your network administrator instructs you
to do so with additional information.
Enter a password (up to 31 alphanumeric characters) as the key to be shared
between the external accounting server and the ZyXEL Device.
The key must be the same on the external accounting server and your ZyXEL
Device. The key is not sent over the network.
Click Apply to save your changes back to the ZyXEL Device.
Click Reset to reload the previous configuration for this screen.
P-334WHD User's Guide
81