ZyXEL Communications p-334whd User Manual page 101

Table 39 PPPoE Encapsulation
LABEL
User Name
Password
Retype to Confirm Type your password again to make sure that you have entered is correctly.
Nailed-Up
Connection
Idle Timeout
WAN IP Address Assignment
Get automatically
from ISP
Use Fixed IP
Address
My WAN IP
Address
Remote IP
Address
Remote IP
Subnet Mask
DNS Servers
First DNS Server
Second DNS
Server
Third DNS Server
WAN MAC
Address
Factory default
Clone the
computer's MAC
address
Set WAN MAC
Address
Apply
Reset
Chapter 6 WAN
DESCRIPTION
Type the user name given to you by your ISP.
Type the password associated with the user name above.
Select Nailed-Up Connection if you do not want the connection to time out.
This value specifies the time in seconds that elapses before the router automatically
disconnects from the PPPoE server.
Select this option If your ISP did not assign you a fixed IP address. This is the
default selection.
Select this option If the ISP assigned a fixed IP address.
Enter your WAN IP address in this field if you selected Use Fixed IP Address.
Enter the remote IP address (if your ISP gave you one) in this field.
Enter the remote IP subnet mask in this field.
Select From ISP if your ISP dynamically assigns DNS server information (and the
ZyXEL Device's WAN IP address). The field to the right displays the (read-only)
DNS server IP address that the ISP assigns.
Select User-Defined if you have the IP address of a DNS server. Enter the DNS
server's IP address in the field to the right. If you chose User-Defined, but leave the
IP address set to 0.0.0.0, User-Defined changes to None after you click Apply. If
you set a second choice to User-Defined, and enter the same IP address, the
second User-Defined changes to None after you click Apply.
Select None if you do not want to configure DNS servers. If you do not configure a
DNS server, you must know the IP address of a computer in order to access it.
The MAC address section allows users to configure the WAN port's MAC address
by using the ZyXEL Device's MAC address, copying the MAC address from a
computer on your LAN or manually entering a MAC address.
Select Factory default to use the factory assigned default MAC Address.
Select Clone the computer's MAC address - IP Address and enter the IP
address of the computer on the LAN whose MAC you are cloning. Once it is
successfully configured, the address will be copied to the rom file (ZyNOS
configuration file). It will not change unless you change the setting or upload a
different ROM file.
Select this option and enter the MAC address you want to use.
Click Apply to save your changes back to the ZyXEL Device.
Click Reset to begin configuring this screen afresh.
P-334WHD User's Guide
101