Canon iR7086 Series Service Manual page 140

Chapter 2
10) Fit the heater unit [1] under the top plate [2], and lead out the connector [3] through the hole [4] in the top plate.
11) Engage the 2 hooks [5] of the heater unit on the TP plate, and secure it in place with 2 screws [6].
12) Fit the connector [2] of the heater to the panel mount [1].
13) Remove the 3 screws [1], and detach the power cord base [2]. Then, mount the included power cord base using the 2 included screws [1].
14) Mount the relay harness unit [2] to the rear side plate using 2 screws [1].
2-82
F-2-268
F-2-269
F-2-270
You will not be using the screw [1] and the power cord base [2] you have
removed from the paper deck.
F-2-271
[1]
[2]